Design & Structure Feature

- It is easily able to be installed between pipes and also possible to replace impeller, mechanical seal without disassembly of pump casing from pipes.
- Pump and motor shaft are made in all-in-one to prevent troubles caused by shaft coupling defects.
- For shaft seal, it is installed with mechanical seal being lubricated by fluid inside pump.
- It realized miniaturization and weight lightening by adoption of aluminum framed motor. (excluding the ones of higher than 15HP being made of die-cast)

Standard Specification

Treating Liquids		Fresh water 0℃~120℃(PH : 6~8)
Operation Range	Capacity	3 ~ 480 ㎥/min
	Head	5 ~ 55m
	Motor Power	1 ~ 100HP
Max. Operation Pressure		10 kgf/㎠
Structure	Impeller	Closed Type
	Shaft Seal	Mechanical Seal Type
Flange		KS 10 kgf/㎠ RF
Motor	Number of Phase	(Three-phase, Four-phase
	Voltage	Lower than 10HP : 220/380V (Higher than : 380V(Y-△)
	Frequency	60Hz
	Insulation Grade	F
	Protection Method	P54
	Type	TEFC
Places to be Installed		Out door Type

 

※ In case of treatment of liquids which are not in high temperature or fresh water, there might be those occasions of marked changes in wear resistance, corrosion resistance according to properties of liquids to be transferred (temperature, concentration, whether or not it contains solids) as well as using conditions and please be sure to inquire of it to our salespersons or the factory. 

Sectional Drawing / Selection Chart

 

Outline Drawing